• HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

It is currently 28 May 2025, 22:14

 [SOLVED] HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

 Forum rules: Click here to view the forum rules

  1. Topic title should contain: the device's manufacturer, full model and the brief description of problem.
  2. Topic message should contain: the PCB marking code (required in case of hardware repairs), an extended description of problem, things you have checked/replaced/measured, your conclusions and the question. If you are not able to find the PCB marking code, please read THIS TOPIC. If you still cannot locate the PCB markings, please upload a clean, both-side photos of the mainboard - it is required to remove any films, modules or brackets possibly covering these markings.
  3. Before posting a new topic please read all topics in TRAININGS subforum and make a preliminary diagnostic based on the content of those trainings.
  4. Uploading of any complete schematics, BIOS / firmware files or any other kind of documentation, or linking to 3rd party websites with such files, is STRICTLY PROHIBITED. You can only upload the small portion of documentation or, link to BIOS file on UNVERIFIED BIOS FILES subforum, which simplifies the diagnostics/repair. You are not allowed to upload more then one complete page of instruction/schematic per single topic. The file you upload must not contain any watermarks, "confidential" markings, links or email addresses and cannot be password-protected.
  5. It is only permitted to describe one faulty device per single topic - you should always open a new topic for each subsequent device.
  6. Requesting of the full schematics, BoardView files, BIOS files or any other kind of documentation is NOT ALLOWED in this subforum. If you need to ask for any of these, you should open a new topic in DOCUMENTATION/BIOS REQUEST subforum.

#1 HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by valieromarco • 24 May 2025, 01:29
This laptop doesn’t turn on.
I got 3,3V but no 5V
Jack led is off
Fan doesn’t spin
CPU is hot
No short on PU12

Voltages PU12

1= 0,2V
2= 0V
3= 0V
4= 0,24V
5= 3,3V
6= 2,9V
7= 5,1V
8= 19,5V
10= 0,24V

Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by Google Adsense [BOT] • 24 May 2025, 01:29

#2 Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by matic • 25 May 2025, 17:10
Hello!

- Measure the resistances to ground on coils PL20, PL21 and on any pin of resistor PR211.
- Measure the voltages to ground on coils PL14, PL16, PL22.

#3 Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by valieromarco • 25 May 2025, 23:35
PL20 rises up to 60K ohm
PL21 133 ohm

PR 211 start from 20M ohm and goes down slowly continuously (voltage 19,5V)

PL 22= 0V and 93 ohm
PL16= 0,81V
PL14= 0V and 48 ohm but raises up

#4 Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by matic • 26 May 2025, 07:57
valieromarco wrote:PL21 133 ohm
This resistance is way too low.
valieromarco wrote:CPU is hot
Is the small core of the APU hot?
If so, these two things points to a damaged PCH part of the APU hybrid.

#5 Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by valieromarco • 26 May 2025, 23:05
Yes it’s the small core becomes hot

Ok resistance is low but I got 3,3V on PL 21
shouldn't it measure 0 volts?

#6 Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on  [SOLVED] 

by matic • 27 May 2025, 09:12
valieromarco wrote:shouldn't it measure 0 volts?
The enable signal on pin 1 of PU11 is present, so this chip is active and 3V is generated on the coil PL21, as it should be. But as mentioned, the resistance to ground on this coil is way too low, which is caused by a damaged APU, and therefore the small core of the APU is hot.

The APU is damaged, that's all.

#7 Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by valieromarco • 27 May 2025, 10:15
Ok thank for all

Re: HP ENVY K206NL mobo DAY11AMB6E0 Rev: E no power on

by Google Adsense [BOT] • 27 May 2025, 10:15
Similar Topics
HP Probook 450 G8 mobo DAX8QAMB8D0 REV D dead
  HP Envy x360 15-fe0220nw mb LA-M794P rev 1.0 identyfikacja układu  [SOLVED]
HP SPECTRE X360 Convertible Model 13-ae019nl motherboard DA0X33MBAF0 rev f. no power
HP Envy 17 - brak 5V
  HP Envy 17-j111en zamiennik procesora  [SOLVED]
HP Envy 17-j111en nie uruchamia się

Who is online

Users browsing this forum: No registered users and 6 guests

_______________________________
All rights reserved. Unauthorised copying of this website's content or any of its part is strictly forbidden.
Any trademarks, brand names, products or services published on this website belong to their legal owners, are copyrighted and used for information purposes only.