Hello!
I want to program the KBC chip IT8226E with Svod 3 programmer using the ZIF128 adapter.
The chip is detected correctly and I can read its content, but there are just "00" through the entire read file.
The erase function goes through successfully as well, but it actually does not erase the chip and throws the error at "Blank check" since the read content remains "00" instead of "FF".
I believe the issue is related to the "Flash ID false" error, reported by the Svod 3 software.
I need to program this chip to use on the NM-C531 board.
I tried to put the pin 98 (ME_FLASH) of this chip to the 3.3V via 1kΩ pull-up resistor, but it doesn't change anything.
KBC chip part of the NM-C531 schematic at the attachment.
I want to program the KBC chip IT8226E with Svod 3 programmer using the ZIF128 adapter.
The chip is detected correctly and I can read its content, but there are just "00" through the entire read file.
The erase function goes through successfully as well, but it actually does not erase the chip and throws the error at "Blank check" since the read content remains "00" instead of "FF".
I believe the issue is related to the "Flash ID false" error, reported by the Svod 3 software.
I need to program this chip to use on the NM-C531 board.
I tried to put the pin 98 (ME_FLASH) of this chip to the 3.3V via 1kΩ pull-up resistor, but it doesn't change anything.
KBC chip part of the NM-C531 schematic at the attachment.
