PlayStation 4 CUH-1116A MB SAB-001 prośba o Pinout gniazda standby na MB

Trafiła do mnie konsola z wyrwanymi padami 4 pinowego gniazda standby. Tak jak temacie, potrzebuje alternatywny pinout. 5V i GND wziąłem z jednego z dwóch kondensatorów obok. Ale szukam 2 pozostałych i nie moge znaleźć.

Hello!

Please, post a clear picture of the damaged board area (connector removed from the board).

It seems the small vias are not damaged, so you should just remove the green solder mask from this vias and solder a thin jump wires on them.
After the repair of pulled paths it is best to secure the connector on the board with a glue.

I wanted to paste the socket in this place and bring thin kynar wires to it. Only then are these points covered by a socket.

So, solder a thin wires to this vias first, place the connector to its place and solder another end of this bridge wires to the connector.
Of course you should use a very thin bridge wires (diameter max 0,2mm) on this two vias that the connector will not be lifted from the board. I see no problem here.

I did it like this picture. I checked the transitions with a multimeter. I don't have a diagram, so I don't know if it's good.

tomek0o7 писал(а):I did it like this picture. I checked the transitions with a multimeter. I don't have a diagram, so I don't know if it's good.
[ Obrazek ]

One wire seems soldered on correct place, but another not.

Highlighted vias from another side of the board:



But this way you should connect the jump wires from top to the bottom side of the board. Is it not easier and more professional to do as suggested in post #4?

This is ok?

tomek0o7 писал(а):[ Obrazek ]
[ Obrazek ]
This is ok?

Yes, exactly.

No power.

Measure the voltages to ground on all pins of this connector.

Only 5V.

Test the power supply according to the following procedure:
- Disconnect the power supply from the console.
- Connect it to the wall socket and bridge the pins 1 and 3 ("5V" and "ACDC_STBY") of small white connector.
- Check, if you get 12V on two big pins, when the pins 1 and 3 of small white connector are bridged.

11,85V

Do you hear a "beep", when you press on the power button?

No.

Problem rozwiązany. Pinouty które ja podawałem i Matic są błędne, przylutowałem przy samym gnieździe kynary i jest ok.

Thanks Matic!