Seagate ST1000LM035 "Cyclic redundancy check" error

*******************************************************************
Manufacturer: Seagate
Model: ST1000LM035
*******************************************************************
Hello!

I have a specified HDD which is not shown under system in "My computer".
It is detected in "Disk management", where it is shown as "Not initialized" device. It also throws an "Cyclic redundancy check error".


The data on the disc is not relevant, I just want to format it and install a system on it.

Show SMART.

arvika hat geschrieben:Show SMART.

I get a little data only - screen below. I tried with two different programs but it is the same.

Try HDDscan or Victoria.
This model is very problematic. Many problems with service area. You can show me log from terminal, but probably drive have problem with SA.

arvika hat geschrieben:Try HDDscan or Victoria.

Screen from "HDDscan" is already attached in post #3.
It is a similar situation with "Victoria" - screen below.

arvika hat geschrieben:You can show me log from terminal

I don't know exactly what you want here. Can you describe how to access it in more detail please. Sorry, I'm not very familiar with the software.
I get the following from command prompt, if it helps. Problematic HDD is "Disk 1".

Terminal scheme:


For 2,5" drive there is only 4 pins, not 8. You will find in internet description.

Terminal is blocked by Seagate, but maybe there will be some information, that we can deduct disk condition.
But as I suppose it is waste time try to fix it

I didn't try the option suggestion in post #6, because I don't have enough software knowledge to do this.

I believe that the issue is related to the "service area" of the HDD. I didn't find the firmware for that drive on the web to repair the SA, so the repair is probably not possible.

The HDD drive was returned to the owner without a solution.
Thank you very much for your help.