• HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter

Forumsregeln:Die Forumsregeln lesen

  1. Der Titel des Themas sollte Folgendes enthalten: den Hersteller der Maschine, das vollständige Modell und die kurze Beschreibung des Fehlers.
  2. Die Themennachricht sollte enthalten: einen PCB-Markierungscode (im Falle von Hardware-Reparaturen), erweiterte Beschreibung des Fehlers, Was wurde überprüft/ersetzt/gemessen + Schlussfolgerungen und, die Frage. Wenn Sie keinen PCB-Markierungscode finden können, du solltest lesen DIESES THEMA. Wenn Sie immer noch keine PCB-Markierungscode finden können, laden Sie bitte ein sauberen Fotos von beiden Seiten des Motherboards - ist es erforderlich, alle Filme und Module zu entfernen, die möglicherweise diese Markierungen abdecken könnte.
  3. Bevor Sie ein neues Thema veröffentlichen, sollten Sie alle Themen im Unterforum AUSBILDUNGEN lesen und machen Sie eine vorläufige Diagnose basierend auf dem Inhalt dieser Ausbildungen.
  4. Das Hochladen vollständiger Anweisungen/Schaltpläne oder BIOS-Dateien / Firmware (oder das Verlinken auf andere Websites mit solchen Dateien) ist STRENG VERBOTEN. Sie können nur den kleinen Teil der Anweisung/Schaltplans oder den Link zur BIOS-Datei in UNVERIFIZIERTE BIOS-DATEIEN platzieren, der die Diagnose und Reparatur für den Themenautor vereinfacht. Sie können nicht mehr als eine vollständige Seite mit Anweisungen/Schaltplänen pro einzelnem Thema platzieren. Die Datei darf keine sichtbaren Wasserzeichen, "vertraulichen" Markierungen, E-Mail-Adressen usw. enthalten.
  5. Pro Thema darf nur eine fehlerhafte Maschine beschrieben werden. Für jede nächste Maschine sollten Sie ein neues Thema öffnen.
  6. Das Anfordern von Schaltplänen, Boardview, MB-Fotos, BIOS-Dateien oder Servicehandbüchern ist STRENG VERBOTEN. Wenn Sie irgendwelche von denen fragen wollen, sollten Sie ein neues Thema in DOKUMENTATION UND BIOS/EFI ANFRAGE Sub-Forum öffnen.

#1 HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 9 Oktober 2025, 15:24
Hello

I have an HP Notebook 17-CN (6050A3261701-MB-A02) that does not charge the battery, it will power on from the battery alone, and also power on from adapter alone, but when both are connected the ACDRV for the adapter mosfets is 0v and laptop will only run from battery, despite the orange LED showing and Windows sees the battery as charging even tho no current is drawn. There does appear to be some slight damage to the battery connector to (see picture of area below)

The mosfets have measured ok all in the Mohm range
S-D = 3.8M ohm
G-D = 5.1M ohm
S-G = 4.1M ohm

S-D = 2.7M ohm
G-D = 4.9M ohm
S-G = 4M ohm

Charging IC is BQ24725A, all measurements appear to be ok, apart from the ACDRV issue. IC and adapter mosfets have been replaced and still same prblem occurs.
Bild
4 = 0v
5= 3.3v
6 = 2.6v
8= 3.3v
9= 3.3v
10 = 0.9v
11= 18.6v
12= 12.4v
13= 12.4v
14= 0v
15= 0v
16= 6v
20 = 18.8v

When i unplug the battery whilst adapter is connected, DC jack LED goes off and ACOK drops to ~200mV.

Below are some other observations i noticed.

ACOK Bat and Adapter = 3.3v
ACOK Adapter only = 3.3v

Bat & Adapter ACDRV at BQ = 0v ACDRV at MOSFET Gate = 0v
Adapter only ACDRV at BQ = 25v ACDRV at MOSFET Gate = 25v

Adapter mosfets with Bat and adapter
S= 0v D= 19v G= 0v
Adapter only S= 19v D= 19v G= 25v

Bild

Thanks

Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von Google Adsense [BOT] 9 Oktober 2025, 15:24

#2 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von tekort 10 Oktober 2025, 09:49
Such melted connector could mean that the metalic part inside is not providing enough contact between motherboard and battery. I would start with replacing this connector.

I see it is a standard HP one so You can take one from some HP scrapboard or You can search for new one.

You can also measure resistance of all battery poles - with battery disconected of course - to the pins on the backside of this connector. If the resistance is higher than +-0.2Ohms on any pin, then this connector needs to be replaced.

#3 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 10 Oktober 2025, 10:03
Hi

The damage to the battery connector doesnt look that serious to have damaged the pins.
Bild
There is continuity on all pins of the battery connector from the pin to the underside of the board all around 0.02ohms.

#4 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von tekort 10 Oktober 2025, 10:10
Inside this connector there is surely residue of carbon which means there are shorts between the poles. With this picture this connector surely must be replaced. I would also avoid connecting battery to it as this can lead to permanent battery failure.

#5 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 10 Oktober 2025, 10:14
tekort hat geschrieben:Inside this connector there is surely residue of carbon which means there are shorts between the poles.


Really? none of the pins are shorting together, and there is clear continuity through the connector for each pin. I can replace it but im not sure that it is the problem.

#6 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von tekort 10 Oktober 2025, 11:42
What caused this burn?

If mosfets go to 0V when You connect AC, then there are two possibilities:
1. the burned connector has a short
2. battery is damaged and has an internal short that blocks charging circuit, otherwise You would see a nice flame ;)

#7 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 10 Oktober 2025, 12:06
I am unsure of the history of the laptop, i recieved it in this state.

The laptop does work on the battery alone, and it works on the adapter alone, but when both adapter and battery are connected the ACDRV from BQ chip drops to 0v and the adapter side mosfets Gate do not open.

I have tried with another battery and it is the same story, there are no shorts on the board that i can see. Resistance on all pins of the battery connector do not show any shorts otherwise it wouldnt be able to power on from the battery?

#8 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von tekort 10 Oktober 2025, 12:39
You can also post measurments on this connector:
- voltage to ground with only adapter connected, no battery
- voltage to ground with battery connected, no adapter
- then with both connected

Powering always works if the battery has the charge inside. Charging on the other hand is more complicated as it uses SMBus interface with SDA signal as data, and a clock with SCL signal. If those signals are missing or wrong, the charging will not start, but the battery still can power up the motherboard.
I will still obide with replacing this connector first hand & if that changes nothing, then go further. Also, remeber to have a known working battery to test this after replacing this connector.

#9 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 10 Oktober 2025, 13:19
Battery connector Adapter only
1= 2.6v
2= 2.6v
3= 3.3v
4= 3.3v
5= ~1.5v (decreasing)
6= 3.2v
7= gnd
8= gnd

Battery connector Battery only
1= 12.3v
2= 12.3v
3= 3.1v
4= 3.1v
5= 3.2v
6= 0v
7= gnd
8= gnd

Battery connector Battery and Adapter
1= 12.3v
2= 12.3v
3= 3.2v
4= 3.2v
5= 3.2v
6= 0v
7= gnd
8= gnd

With any of the above configuratins on the BQ chip, SDA and SCL are 3.3v

I have tried with a known working battery and still same result.

Replacing battery connector made no difference.

#10 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von tekort 11 Oktober 2025, 12:41
Ok, so now we know this connector is solid and in good shape ;) It still would be nice to know what led to this kind of failure. Post the HP PN found on sticker of the board & full model name of the device to better recognize the MB. Also post the type of KBC.

Was the board spilled?
Was there any signs of burned components when You first started working with the MB?
Was any of MOSFETs or ICs damaged previously?

As there is no documentation for this board, we need to search a similar platform to this one and then proceed further. Make good photos on both sides of the board and some better pictures of charger area with good lighting. Also post all voltages to ground of charger IC pins when adapter and battery is connected.

#11 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von Vogelek23 11 Oktober 2025, 13:24
Check Q6012 transistor if there is any short circuit between drain (pins 5-8) and source (pins 1-3). Measurement must be done after disconnecting all the power and waiting 1-2 minutes until all capacitors are discharged.

#12 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 12 Oktober 2025, 18:38
@tekort
Yes but unsure on the history of the laptop and what caused the problem, HP part number is M50452-601, cant find any schematics/boardview online, i thin it is same similar board to the HP 470 G8 model. Laptop full model is Notebook 17-CN0534SA.

KBC = IT8987E

No signs of liquid damage at all.

No damage to any components that i could see on initial inspection. BQ measurements are in OP.



Hi @Vogelek23

Q6012
No, i dont think there is any short there,
D-S = 150k ohm
D-G = 2.8M ohm
S-G = 2.9M ohm

#13 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von tekort 13 Oktober 2025, 10:51
Post good quality photos of both sides of whole the board as mentioned in my post #10

#14 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 13 Oktober 2025, 13:41
tekort hat geschrieben:Post good quality photos of both sides of whole the board as mentioned in my post #10


Bild
Bild
Bild

#15 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von tekort 13 Oktober 2025, 17:30
KenM0560 hat geschrieben:@tekort

No signs of liquid damage at all.



There are some signs of BIOS chip replacement & some pads there were repaired. Originally on this board was Winbond W25Q64**** chip and You have ISST (?) Remove the CPU foil to make sure that the CPU was not spilled.

#16 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter


von KenM0560 13 Oktober 2025, 17:38
Laptop was recieved with the ISSI chip, and two pulled pads, they were repaired and BIOS is working as it should now, it wasnt liquid damage.

Bild

#17 Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter  [GELÖST]


von KenM0560 17 Oktober 2025, 10:22
Problem was solved by replacing both battery mosfets and soldering another BQ IC.

Re: HP Notebook 17-CN (6050A3261701-MB-A02) - No Charge, No ACDRV with Battery & Adapter  [GELÖST]


von Google Adsense [BOT] 17 Oktober 2025, 10:22

Wer ist online?

Mitglieder in diesem Forum: 0 Mitglieder und 1 Gast

_______________________________
Alle Rechte vorbehalten. Das unerlaubte Kopieren des Inhalts dieser Website oder eines Teils davon ist strengstens untersagt.
Alle auf dieser Website veröffentlichten Marken, Markennamen, Produkte oder Dienstleistungen gehören ihren gesetzlichen Eigentümern, sind urheberrechtlich geschützt und werden nur zu Informationszwecken verwendet.