• Dell N4110 can't switch on

Pravila foruma:Klikni tukaj za prikaz pravil na forumu

  1. Naslov teme mora vsebovati: proizvajalca naprave, poln model in kratek opis okvare.
  2. Sporočilo teme mora vsebovati: oznako tiskanega vezja (v primeru popravil strojne opreme), razširjen opis okvare, kaj je bilo preverjeno, zamenjano in/ali izmerjeno, sklep in vprašanje. Če ne morete najti oznake tiskanega vezja, morate prebrati TO TEMO. Če še vedno ne najdete oznake, prosim objavite kakovostne fotografije obeh strani matične plošče - potrebno je odstraniti vse folije in module, ki bi lahko zakrivali te oznake.
  3. Pred objavo nove teme, preberite vse teme v podforumu USPOSABLJANJA, in naredite predhodno diagnostiko na podlagi vsebine teh usposabljanj.
  4. Nalaganje celotnih navodil/shem, BIOS / firmware datotek, ali objavljanje povezav, ki vodijo do drugih spletnih strani s takšnimi datotekami, je SROGO PREPOVEDANO. Lahko objavite le majhen del navodil/shem, ali povezavo na BIOS datoteko v podforumu NEVERIFICIRANE DATOTEKE BIOS/EFI. V eni temi ne smete objaviti več kot eno stran navodil/shem. Datoteka ne sme vsebovati vidnih žigov "zaupno",, e-poštnih naslovov ipd.
  5. V eni temi lahko opišete SAMO eno napravo. Za vsako drugo okvarjeno napravo morate odpreti novo temo.
  6. Zahteve za sheme, boardview, fotografije matičnih plošč, datoteke BIOS-a ali servisne priročnike za storitve NISO DOVOLJENE. Če želite vprašati za katero koli od teh, odprite novo temo v podforumu ZAHTEVA ZA DOKUMENTACIJO & DATOTEKO BIOS/EFI.

#1 Dell N4110 can't switch on


Napisal/-a cygron 28 Julij 2025, 07:45
Model : Dell N4110
Board id: DAV02AMB8F1 Rev: F

Laptop can't switch on. 3V 5V is ok. When press power key, RUN_ON is not coming. BIOS and EC flashing can't solve the problem. Need help.

Re: Dell N4110 can't switch on


Napisal/-a Google Adsense [BOT] 28 Julij 2025, 07:45

#3 Re: Dell N4110 can't switch on


Napisal/-a cygron 1 Avgust 2025, 14:51
PL10 - 5V
PL11 -3.3V
PL3 - 0.2V (Without Battery)
All other coils have 0V.

Resistance to ground on coils
PL10 - about 1K
PL11 - 170 Ohm
PL3 - about MOhm
PL8 - 330 Ohm
PL9 - 430 Ohm
PL4 - 5 Ohm
PL1 - 26 Ohm
PL2 - 14 Ohm

#4 Re: Dell N4110 can't switch on


Napisal/-a matic 17 Avgust 2025, 18:23
cygron napisal/-a:PL11 - 170 Ohm
This resistance is definitely too low.
Remove the coil PL11 from the board and measure the resistances to ground on both pads on the place of this coil.

#5 Re: Dell N4110 can't switch on


Napisal/-a cygron 12 Oktober 2025, 14:03
Sorry for my mistake. Resistance to ground on coil PL11 is 340 Ohm.

#6 Re: Dell N4110 can't switch on


Napisal/-a matic 13 Oktober 2025, 07:11
This resistance still seems a bit too low.
Perform the measurements suggested in post #4.

#7 Re: Dell N4110 can't switch on


Napisal/-a cygron 13 Oktober 2025, 10:32
+3.3V_ALW side has 340Ohm and +3.3V_LX has 27 K.

#8 Re: Dell N4110 can't switch on


Napisal/-a matic 13 Oktober 2025, 13:11
Inject 3.3V from the laboratory power supply to the "+3.3V_ALW" power rail.
What electrical current flows from the laboratory power supply during the test?

#9 Re: Dell N4110 can't switch on


Napisal/-a cygron 13 Oktober 2025, 13:37
0.007 amp for a few seconds and then stop.

#10 Re: Dell N4110 can't switch on


Napisal/-a matic 14 Oktober 2025, 07:29
Is the resistance to ground on this power rail still the same?
Also measure this resistance with the reversed polarity of test leads.

#11 Re: Dell N4110 can't switch on


Napisal/-a cygron 14 Oktober 2025, 14:04
With the reversed polarity of test leads, the result have the same. 340 Ohm.

#12 Re: Dell N4110 can't switch on


Napisal/-a matic 16 Oktober 2025, 08:59
Unfortunately, there is no jumpers on this board to locate the source of low resistance.
Remove the KBC chip from the board and remeasure the resistance.

#13 Re: Dell N4110 can't switch on


Napisal/-a cygron 8 December 2025, 15:37
Remove the KBC chip from the board and the resistance is about 6k. Can i replace IT8518E from other laptop motherboard?

#14 Re: Dell N4110 can't switch on


Napisal/-a matic 9 December 2025, 08:32
cygron napisal/-a:Can i replace IT8518E from other laptop motherboard?
Yes, you can, but make sure the extension markings (such as -CXS or similar) matches the original.

#15 Re: Dell N4110 can't switch on


Napisal/-a cygron 12 December 2025, 03:40
Original is 1145-CXS. Can i replace with 1203-CXA?

#16 Re: Dell N4110 can't switch on


Napisal/-a matic 12 December 2025, 08:03
I think such a replacement should work, but it's impossible to know without a test.

#17 Re: Dell N4110 can't switch on


Napisal/-a cygron 12 December 2025, 13:35
I replace 1145-CXS with 1203-CXA but laptop does not turn on.

#18 Re: Dell N4110 can't switch on


Napisal/-a matic 12 December 2025, 15:47
Remeasure the resistances to ground on coils PL10, PL11 and on pin 7 of chip PU7.

#19 Re: Dell N4110 can't switch on


Napisal/-a cygron 14 December 2025, 14:41
PL10 - 6K to 48 K (not stable)
PL11 - about 6K
Pin 7 of chip PU7 - about 170K

Re: Dell N4110 can't switch on


Napisal/-a Google Adsense [BOT] 14 December 2025, 14:41

Kdo je na strani

Po forumu brska: Baidu [Spider], MendUsThis in 4 gostov

_______________________________
Vse pravice pridržane. Nepooblaščeno kopiranje vsebine te spletne strani ali njenega dela je strogo prepovedano.
Vse blagovne znamke, izdelki ali storitve, objavljene na tej spletni strani, pripadajo njihovim zakonitim lastnikom, so avtorsko zaščitene in se uporabljajo samo v informativne namene.