HP Pavilion 15-p033tx No Display

Model : HP Pavilion 15-p033tx
Board id : Y11A DAY11AMB6E0 Rev - E

Laptop is power on. But no display. Caplocks led blinks continuously. Try to recovery bios with Windows Key + B or V, not success. CMOS battery is bad and replaced CMOS battery with good one. Not good. So i try to flash bios with found one from internet ( HP Pavilion 15-P020SW Quanta Y11A DAY11AMB6E0 REV:E ) not exactly same model. But problem still exist. And i notice CMOS battey is drain very fast. I replaced 3.3 V cmos battery and a few minutes later it has 2.9V. What happen?

Measure the true ground resistance on the + pin of the RTC battery (battery disconnected).
Power on measurements.
Measure voltage and resistance to ground on all coils.

Ground resistance on the + pin of the RTC battery (battery disconnected) - 30M and above

PL20 - 5V ( 40K and above not stable )
PL21 - 3.3V (3.6 K)
PL22 - 1.3V (171 Ohm)
PL16 - 1.0V (106 Ohm)
PL12 and PL13 - 0.9V (8.1 Ohm)
PL14 - 1.7V (71 Ohm)
PL8 - 2.8V ( 40K and above not stable )
PL9 - 1.3V (430 Ohm)

Disconnect the RTC battery from the board and connect the laboratory power supply to the RTC battery connector. Set the voltage to 3V. What electrical current flows from the laboratory power supply in this case?
You will probably have to measure the current with multimeter, because it will be probably so low, that the meter on laboratory power supply will not show it.

Finally found the problem. C367 (Green Circle) leak. RTC_RST# is about 2.3V (low). Remove C367 and laptop run normally. Thanks you all Machine and matic for your helping. Best regards.